Front axle seal. Kubota L3540.

[hunt4570]

So Kubota L3540, and I obviously have a seal gone out on the front axle left side (4x4). So, my question is, how hard is it to replace? I have decent mechanical skills but have not done this before, any special tools needed to do this?
Thanks in advance!

 

[Mike1955]

Mr hunt I have not done this job before. I do own an L4330 Kubota. I don’t think you need anything special. Since it’s your first maybe a little extra patience. I’d rather struggle at home with it than to take it somewhere and WAIT. Then pay about three times what it should cost. Change it

 

[hunt4570]

Mr hunt I have not done this job before. I do own an L4330 Kubota. I don’t think you need anything special. Since it’s your first maybe a little extra patience. I’d rather struggle at home with it than to take it somewhere and WAIT. Then pay about three times what it should cost. Change it

And the same thing happened couple three years ago it cost me like $275. Not including my hauling it an hour to the Kubota dealer. I’m thinking about doing it. Watched a couple videos don’t look too bad.

 

[Harry in Ky]

Do it yourself. At today's rates it could cost $275 to have them take the tire off an put it back on.

 

[JJT]

Not a hard job. Get a decent set of snap ring pliers. I needed both internal and external pliers. It was less than a 90 minute job, (I work slow....).

 

[repete]

Get a manual and dig into it. Just be certain of where the leak is from and be CERTAIN that there are no parts in need of replacement such as bearings, shafts and housings.
I had to replace a $600 dollar housing that cracked likely because I put more load on the outer bearing when I reversed the rims to get a wider stance on my 2550. Have run it with the wheels in the "inner" position for a couple thousand hours with 0 issues.

 

[hunt4570]

So I have decided to take it to the dealer. I have also had a loss of power issue I've been fighting for a while so I'm going to take it in and let them check it out as well.

L3540 hydro power questions

I have an L3540 Hydrostatic 4 wheel drive tractor, have had it maybe 8-9 years. This problem seems new or has been slowly getting worse and I'm just starting to notice it.. When I have a mower on and either going on flat land or downhill it seems to be fine, BUT on even a slight upgrade I seem...

www.tractorbynet.com