I just read mostly_gas's thread and I may have the same or a similar problem. I may have the same problem, need advice. I just started my 1700 and while changing implements and letting it idle, the guage went to hot. I lifted the hood and saw what looks to be antifreeze comming from between the gas tank and the rear of the engine. My question, is there a freeze plug or a core plug there, or niether? I can not see it without taking the tank off. Is this something I can fix myself? Where did you get your plugs?
Freeze plug or core plug, need advice, Ford 1700
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
I already replied to your post over there.. here's a link.. it's too much work to retype, paste and upload a new pic.
http://www.tractorbynet.com/forums/...ing/153128-freeze-plug-blues.html#post1763311
soundguy
http://www.tractorbynet.com/forums/...ing/153128-freeze-plug-blues.html#post1763311
soundguy
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
hammer,screwdriver and pair of pliers.. either knock a hole in it's center ..push screwdriver in about half inch and then twist it to the side and pull out with pliers.. or tap it near a side edge witht he screwdriver till it spins... then yank out..
they are soft metal.. they give way pretty easilly.
soundguy
they are soft metal.. they give way pretty easilly.
soundguy
