Donna Belcher
New member
how hard is it to remove? the freeze plug and how do you do it
Freeze Plug in John Deere 855 tractor leaking
- Thread starter Donna Belcher
- Start date
- Views: 1684
-
- Tags
- john deere 855
GManBart
Elite Member
- Joined
- Dec 10, 2012
- Messages
- 4,976
- Location
- Detroit, Michigan
- Tractor
- Massey Ferguson 241, Kubota SVL90-2
Welcome to TBN!
Generally speaking, just a hammer and a chisel or screw driver....hammer in on one side, which rotates it until you can grab it with vice grips, and pull it out. There are lots of videos online that show how to do it...worth watching one or two.
Generally speaking, just a hammer and a chisel or screw driver....hammer in on one side, which rotates it until you can grab it with vice grips, and pull it out. There are lots of videos online that show how to do it...worth watching one or two.
Tractorboy88
Silver Member
- Joined
- Jan 4, 2016
- Messages
- 105
- Location
- Hemingway, SC
- Tractor
- Ford 7000, 2000, New Holland TS-135A, John Deere 7400
Welcome!
Once you get the old one out, if its hard to access, they make a rubber expandable plug type that works well. It has a bolt through it with a nut that you tighten, which causes the rubber plug to expand. Similar to a boat drain plug. Most auto parts stores have them.
Good Luck!
Once you get the old one out, if its hard to access, they make a rubber expandable plug type that works well. It has a bolt through it with a nut that you tighten, which causes the rubber plug to expand. Similar to a boat drain plug. Most auto parts stores have them.
Good Luck!
Billrog
Veteran Member
- Joined
- Dec 9, 2014
- Messages
- 2,053
- Location
- Armstrong, British Columbia
- Tractor
- Kioti 2610, 580 SuperM Case Backhoe
Gently, they are thin metal you can punch a screw driver threw near one edge then pry it out enough to get hold of it with pliers if necessary.
