Ford 917L 60" Flail Pully

Jeepdoc78 · Jul 13, 2022

Hello all,
Last year I picked up a Ford 917L flail to use behind my 855 in an effort to keep the pastures around my house in check. I installed all new cutters from Flailmaster and it worked fairly well. The cut was great but the unit had some vibration. Upon inspection I could see the pulley on the cutter shaft moving. Turns out it's not the stock pulley and actually has a tapered bore (shaft is straight). I can grab it and wobble it back and forth.

The pulley is measuring 5 inches across. Can someone with a 917L measure the pulley on their flail so I can try to source the correct size pulley?
Thank you!

Harry in Ky · Jul 13, 2022

Schematic, Manuals, Specifications and Diagrams for Blades, carrier & drive parts | New Holland AG | MyCNHi US Store

Find schematics, manuals, specifications and diagrams for BLADES, CARRIER & DRIVE PARTS. Find genuine OEM parts for your needs.

www.mycnhistore.com

Could this be it?

Jeepdoc78 · Jul 13, 2022

Hello Harry,
That is the drawing/pulley I am asking about. The only price I can find for that part is around $290. I am hoping to find out the diameter so I can try to source one that is a bit lower in cost.

Thank you.

Harry in Ky · Jul 13, 2022

I see. I hope you have better luck than I'm expecting. I'd say the odds of someone reading your message and actually having a similar machine, built for only a couple years some twenty or so years ago are probably pretty slim. I do however, have a few ideas on some options you might consider if that doesn't come through for you.