Ford 3000 Starting Issues? Having to hotwire currently

   / Ford 3000 Starting Issues? Having to hotwire currently #1  

SupaMav68

New member
Joined
Apr 15, 2020
Messages
2
Tractor
Ford 3000, Farmall Model A
Howdy Everyone-

First time on here. I have a gas Ford 3000 that is having starting issues. I replaced the ignition switch, points, condensor, coil, plugs and wires. The tractor turns but will not start. I have fuel. I'm currently having to hotwire the tractor (battery jumper to coil) to get it to run. Does anyone have any idea what my problem could be?
 
   / Ford 3000 Starting Issues? Having to hotwire currently #2  
Does it perhaps have an open ballast resistor?
 
   / Ford 3000 Starting Issues? Having to hotwire currently
  • Thread Starter
#3  
No, It doesn't look to have a ballast resistor.
 
   / Ford 3000 Starting Issues? Having to hotwire currently #4  
are you getting 12v from the wire to the coil when the key is on? i would start there.
 
   / Ford 3000 Starting Issues? Having to hotwire currently #5  
With the key on you should read twelve volts on one side of the coil. With the points open you should read twelve volts on both sides of the coil. When the points close you should continue to have twelve volts on one side of the coil but the other side should be zero.
 

Tractor & Equipment Auctions

2017 SANY SY365C LC EXCAVATOR (A51242)
2017 SANY SY365C...
2014 VOLVO VNL DAYCAB (A50854)
2014 VOLVO VNL...
2016 POLARIS RAZOR XP1000 (A51222)
2016 POLARIS RAZOR...
2008 FORD F-350 (A50854)
2008 FORD F-350...
2025 LandHonor LHR-DFP10 Diesel Fuel Transfer Pump with Hose Reel (A49461)
2025 LandHonor...
2021 CATERPILLAR D3 LGP CRAWLER DOZER (A51242)
2021 CATERPILLAR...
 
Top