I am getting ready to change out the hydraulic filter in my tractor. I have noticed that the fluid is milky white which i know means water has gotten into the system. What i would like to ask is, can i drain the fluid and then pour diesel fuel in to clean out the trans area before putting all new fluid in? If not then how to clean the inside of trans area.
Hay Dude
Epic Contributor
- Joined
- Aug 28, 2012
- Messages
- 26,143
- Location
- The Last Red State in the Northeast
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT555D, Challenger MT535B Krone 4x4 XC baler, 2-Kubota ZD1211’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mower, NH wheel rak
I don’t know how much fluid your trans holds, but might be best to buy some economy priced fluid and run it a little while, then drain it. See if it still looks milky, if yes, do it again until you get clean oil, then put the good stuff in. Little more expensive, but you can run the fluid through all the internals that way whereas diesel would be more of a flush with tractor standing still.
Ive seen it where diesel has been used, but I dont think it is as thorough as a fill & drain with trans fluid.
Ive seen it where diesel has been used, but I dont think it is as thorough as a fill & drain with trans fluid.
