FOOT STEP B2710, B2910 & B7800

ronjhall · Dec 21, 2005

A couple of weeks ago it was asked if there was a foot for a B7800 in this thread. Click Here
I stopped at my dealer. He said that he had installed a couple of steps on a B7800 using step from a L2800. I ordered one. Part # TA140-47470. $19.25 plus tax.
Installed it today. Attached a picture.
I have not check to see if there is any interference with a MMM. There should not be. Some B3030 owners have mounted a similar step on their tractors.

ronjhall · Dec 21, 2005

Used a bolt that already existed to mount right side. Then drilled a another hole for second bolt. Picture attached.

ronjhall · Dec 21, 2005

Made a angle bracket to mount left side. Picked up rubber floor mat and drilled 2 holes for bracket. Picture attached.

DAP · Dec 21, 2005

Ron ... it twas I who asked that initial question. You didn't happen to make 2 of those angled brackets did ya! ??? LOLOL

FYI ,, the B3030 CAB model comes with a factory step I believe. Before trying to adapt the L2800 step, I'm trying to find someone who'll snap a pic of their B3030C step for me.

That's I nice clean job Ron ... If I had a way to fab that angle bracket, I'd probably go that route.

/forums/images/graemlins/smirk.gif

ronjhall · Dec 21, 2005

Well I did. Thought I was going to use one on both sides of bracket. I am not sure if bolt pattern is the same.
EDIT: Checked bolt pattern. They are different by 1/4". /forums/images/graemlins/frown.gif

rswyan · Dec 21, 2005

Outstanding - thanks for the tip !

DAP · Dec 21, 2005

You're kidding right?

omg THATs too funny

Now what! /forums/images/graemlins/smile.gif

This should be simple!

ronjhall · Dec 21, 2005

<font color="blue"> You're kidding right?
</font> Nope.
PM me with a address that I can mail it to. I'll drill the hole in correct spacing. /forums/images/graemlins/grin.gif

robertm · Dec 21, 2005

Sure wish they had something like that for my B7510. I'm afraid my fat a$$ would bend the floorboard with that configuration. I'm working on another step type now. I'll post it if I gett 'er done.