I think I at have a bad switch because I bought 2 footcontrols I wired the other one up tonite and it works but when I wired up the one Ivebeen trying to get to work the sae way it still does not work!!! way to test switch??
foot controler
- Thread starter mike cook
- Start date
- Views: 2098
SPIKER
Elite Member
Use a meter to test from (C) common to the (NC) normally closed. the meter should pass power thru just like it has the two leads together. PUSH switch the signal shod show OPEN. Move lead from (NC) to (NO) and test again, the meter should read OPEN when switch is off and CLOSED (just like leads together) when pushed.
Check to make sure that you have the drill press switch turned ON when trying the foot switch.
Mark
Check to make sure that you have the drill press switch turned ON when trying the foot switch.
Mark