few 4410 hydraulic questions

[ohioboy]

I've installed a solenoid selector valve on my tractor for grapple on loader. I bought it from baileynet (can't locate part no. at moment) and it was less $ than surplus center, works well, but there's a little issue...
In addition to -6 inputs/outputs it has an sae-4 drain port for fluid that somehow gets past spool.
It pisses a little fluid from here.
Other than plumbing this port back to some type of tee arrangement at rear end vent/fill, is there another more convenient place further forward to plumb it to tank?
I've got ePowerReverser trans

Also, who's/which top n tilt do you guys recommend?? And which/who's tip for pioneer coupler??

Thanks in advance!

 

[Zebrafive]

Looks like key#4 in this picture would work

 

[ohioboy]

Thanks, I'll look there. I should be able to plumb a 1/4" line to dump there.

 

[ohioboy]

I checked out the suggested location and its on left side of machine essentially above rear axle.

Does anyone see why I can't/shouldn't plumb this dump line to the valve manifold's tank galley?

The valve manifold is only a few feet behind loader/selector valve on right side of transmission housing.
I'm assuming it's unrestricted to tank, i.e. no/little pressure

I'd have to source metric adapter fitting for that connection.

Thanks in advance again!!

 

[danedgington]

Is there any reason you ca 't just plug the -4 so once it is full and is just full of what slipped past the spool?

 

[ohioboy]

Tried that. Still wants to push fluid past plug which lends me to believe it needs to be plumbed to tank.
Trying to compress/fight fluid on the wrong side of seal can't be a good thing for longevity.

 

[J_J]

Just send the out flow from that port back through the closest return hose.