I am placing this here for a reminder. I installed the fender light kit on the BX this weekend. I did take some pictures and will post those this evening. All in all, took me about three hours start to finish including gathering the tools, breaks (it was hot and humid) and the clean up. I found a few things out that worked well. The kit from Kubota was nice but the pedestals were a tad too wide so they over hang the fender about an eighth of an inch. I may go back and thin the pedestals thus moving them in to fit but that's a different project.
Fender light install
- Thread starter meos1
- Start date
- Views: 2656
wmonroe
Elite Member
Lets see the pictures!
wmonroe
Elite Member
Looks good. Is that the factory bota kit?
Yep. It's nice but a tag wide by 1/8 inch. I would like to shave that pedestal down so it is flush. I would really like to take a quarter inch off it but that's getting extreme. Maybe this winter but I needed the lights for getting the grass cut.
Here are some similar links:
