FEL Control Valve Body, Banjo Fitting Seals

   / FEL Control Valve Body, Banjo Fitting Seals #1  

Scrambler82

Veteran Member
Joined
Jul 13, 2010
Messages
1,095
Location
SoCal
Tractor
Mahindra Max 28XL, HST, TLB
I own a MAX28XL, 2014, 500 hours.
I have done a lot of earth moving, digging, Field work with it and the MAX has performed well.
In the last six month the FEL Control Valve started leaking, I finally decide to clean it up and found one of the Banjo Fittings is leaking.
I removed the fitting and found the Washer/Rubber Seal was leaking and it had gotten worse over the last six months.

So, I have looked on the Web for these seals but I have not been lucky enough to find one. I finally contact a Site called "Mahindra Parts Direct" !
They want $20.00+ for one, now I know we are talking high pressure, which means $$$, but $20.00 for one seal was just too much for me.

I am dealing with "Shearwood Tractor Parts" at the moment, waiting for a picture of the Seal, just to make sure it at least looks like the item.

I have tried three Hydraulic Shop in my area without finding something similar, so I am up in the air at what to do.

Does anyone know a Shop that sells Banjo Fitting Seals for flat surface mounting.

Any help would be appreciated.

Thanks for your time / GOD Bless
 
   / FEL Control Valve Body, Banjo Fitting Seals #2  
Banjo fittings typically seal with either a copper washer or a bonded seal, also called dowty washer. These things cost less than $1 each and that's on the high side. Heck, $20 is probably a box full of those.

You'll have to measure the outer diameter of the banjo bolt to figure out the size of the dowty washer. It's most likely metric.

I don't how an hydraulic shop can call themselves an hydraulic shop without having this stuff in stock or even the will to help you out on something so simple.

A couple of sources:




1748553532929.jpeg
1748553628558.jpeg
 
   / FEL Control Valve Body, Banjo Fitting Seals
  • Thread Starter
#3  
That's them and I never thought of McMaster.
Thanks
 
   / FEL Control Valve Body, Banjo Fitting Seals
  • Thread Starter
#4  
Banjo fittings typically seal with either a copper washer or a bonded seal, also called dowty washer. These things cost less than $1 each and that's on the high side. Heck, $20 is probably a box full of those.

You'll have to measure the outer diameter of the banjo bolt to figure out the size of the dowty washer. It's most likely metric.

I don't how an hydraulic shop can call themselves an hydraulic shop without having this stuff in stock or even the will to help you out on something so simple.

A couple of sources:




View attachment 3533258 View attachment 3533259

Done !

Thanks
 

Tractor & Equipment Auctions

1264 (A50490)
1264 (A50490)
2004 IC Corporation 3000IC School Bus (A51692)
2004 IC...
CFG MH12RX Mini Excavator (A49461)
CFG MH12RX Mini...
2011 Ford F-150 4x4 Crew Cab Pickup Truck (A50323)
2011 Ford F-150...
2012 Bobcat S850 (A50120)
2012 Bobcat S850...
2004 GREAT DANE 53FT REEFER TRAILER (A52141)
2004 GREAT DANE...
 
Top