Draw bar use
- Thread starter Grjfer
- Start date
- Views: 4763
Bobrown14
Gold Member
mount it all the way in towards the front of the tractor. Extend it when you need to.
The way you have it in the pic will interfere with an attachment.
The way you have it in the pic will interfere with an attachment.
jyoutz
Super Star Member
I remove the drawbar when using an attachment. Many don’t have a forward setting.
jeff9366
Super Star Member
- Joined
- Jan 14, 2011
- Messages
- 12,787
- Tractor
- Kubota Tractor Loader L3560 HST+ ~~~~~~~~~~~~~ 3,700 pounds bare tractor, 5,400 pounds operating weight, 37 horsepower
Rear/Center Tractor Drawbar // USE TODAY
For brute pulling tasks I use the rear/center tractor drawbar as my preferred attachment point. Photo #1 + #2 I never remove the 3/8" clevis-mount Chain Grab Hook from the rear/center drawbar. I usually pull heavy loads with 5/16" Grade 70 chain, which is a secure fit in the 3/8" Chain Grab...
www.tractorbynet.com
CobyRupert
Super Member
I’ve never had a drawbar interfere with an attachment. For me, it’s the attachment’s PTO shaft that can get bent on an extended drawbar when you lower the attachment. Especially in situations, on a bank or ditch, where the attachment is lower than the tractor.
If OP hooks anything to that clevis, it’s going to be fighting that ball hitch.
Bearsixty7
Veteran Member
- Joined
- Jun 10, 2015
- Messages
- 1,538
- Location
- St. Paul TX
- Tractor
- LS MT240HE (6/2020). JD LA145. TYM T754C (6/10/25)
Most people would have the them switched, put the ball in the forward hole and then the end hole can be used for the clevis or regular trailers or implements.
LS Tractor Owner
Super Member
- Joined
- May 1, 2017
- Messages
- 7,665
- Location
- Edgewood, NM
- Tractor
- LS XG3025 TLB, Previously MT125 TLB, Craftsman GTS6500
Yep, same here..... hangs on the wall until I need to move the trailer.
