DK45HST Rear remotes, size and fitting

airlynch · Aug 29, 2014

Hello first post. Bought a 2013 DK45 HST this summer (26 hrs so far so good). I just purchased and put together a 3pt log splitter and need to buy hoses and fittings. I think the rear remotes are 1/2" but not sure what other spec to reference for the male quick connections. A few questions I am hoping you can help me with:

-Are the rear remotes 1/2"?
-What male quick connect fittings do I need?
-What is the psi and gpm at rear remote?
-Of the rear remotes which is supply and which is return? (note: I added a second set of rear remotes on purchase but not sure if the set runs vertical or horizontal, think its vertical but want to verify)

Thanks for your help

ksbrdmkr · Aug 30, 2014

Pioneer 1/2 in. Standard ISO Tip, 3/4 In., 16 ORB, Fits All Current Models, Ball Style, from the TSC web site. You have two sizes on these fitting, threads size and tip size. I believe on my DK 45 SE The loader tips are 1/2 and the rear remotes tips are 3/4in. The way mine are set up pulling back on the hyd control operates/pressurizes the bottom remote( usually extending the cylinder) and the top remote is pressurized with the foward movment of the control( lowering or collapsing the cyl). Usually the tip is one size larger than the hose for the same flow.

airlynch · Aug 30, 2014

Thanks. I will let you know how it goes. Much appreciated.
Dan

J_J · Aug 30, 2014

Total Pump Flow 16.8 gpm (63.9 L/min)

k0ua · Aug 30, 2014

1/2 inch "AG" also known as Pioneer, also known as ISO 5675. ISO 5675 Agricultural Hydraulic Quick Couplers

each set is vertical, Up and Down. neither one is source or tank, they are both functions depending on which way you push or pull the control valve lever.

Total flow is 10GPM at the remotes.. The other 6 is for the power steering which is totally hydraulic (no mechanical connection from the steering wheel to the front wheels)

airlynch · Aug 31, 2014

Thanks everyone for the help. I was able to figure it out after some trial and error. I am dead tired but was able to put up a lot of wood today. Thanks again for all the help and that is not only on this issue, but I relied on your posts as a vital part in my decision on buying the Kioti DK45se HST. I am now 30 hours in and it has exceeded my expectations. The work that you can do with these is truly impressive. Here are some pic's: