DK-45 PTO relay

[Cletrac]

The PTO on my DK-45 will not latch on when I push the button on the fender. If I hold the button down the PTO will run but when I let go the light goes out and the PTO stops. I pulled the dash apart to get to the two relays that run the PTO and they both switch but one must need to stay latched to keep to PTO on after the button is released. I don't have a service manual to see what the wiring diagram looks like and my dealer is an hour plus away on a trailer to take the tractor back. I have no problem buying a new relay but I need to know which one to order. Anyone out there have this same problem?

Thanks in advance
Dave

 

[DK45C_Dave]

Hi Dave,
The fender button on mine stays in when I push it to start the PTO and comes back up when I push it again to turn it off. Could the button on yours just not stay locked in? It sounds like the relays are working.
Good luck,
David

 

[KiotiJohn]

Sounds like the switch to me also, not the relays. The dealer may send someone out with a new switch, it's under warranty. John