DIY bucket
- Thread starter Takman
- Start date
- Views: 2154
dfkrug
Super Member
- Joined
- Feb 3, 2004
- Messages
- 7,760
- Location
- Santa Cruz Mtns, CA
- Tractor
- 05 Kioti CK30HST w/ Prairie Dog backhoe, XN08 mini-X
I made a 13" bucket for my homebuilt CADDigger years ago. To curve the 1/4" mild steel plate, I used 2 cable come-alongs and an O-A torch to heat it up a section at a time. As I bent it, I welded it to the side plates. Worked great.
24" is pretty wide. What I would do today is use a thinner carcass plate, 3/16 or even 1/8", and add wear plates to the outside of the curve. For yours, you could bend 2 pieces of plate, and weld them together in the middle. Wear plates can be a couple of inches wide, so they would be easy to bend.
24" is pretty wide. What I would do today is use a thinner carcass plate, 3/16 or even 1/8", and add wear plates to the outside of the curve. For yours, you could bend 2 pieces of plate, and weld them together in the middle. Wear plates can be a couple of inches wide, so they would be easy to bend.
MH8675309
Platinum Member
Agree with dfkrug. I made a skid plate for my haybine in a very similar manner. Take your time and do a nice job and you'll be pleased with your work. Or you could have a fabrication shop put a radius in it for you $$
