Deutz Hydaulics/Power steering

   / Deutz Hydaulics/Power steering #1  

BIGCRYER

New member
Joined
Dec 6, 2010
Messages
3
Tractor
Deutz 4006
Have a Deutz 4006. Installed a new hydraulic pump, the old one was shot, and have not been able to get the new pump to work consistently. Have tried a number of thing that were suggested locally, but either get a cycle or two or no results. Has anyone had/solved a similar problem.
 
   / Deutz Hydaulics/Power steering #2  
I can't tell if you said it ran any length of time, or it turned a few times and lost its prime. Is the circuit complete such as pump to valve, cylinder/motor, etc? Did you fill the pump to start with. A gear pump should self prime if not too much height difference.
 
   / Deutz Hydaulics/Power steering
  • Thread Starter
#3  
It was just a few cycles. I am wondering if the oil lines have a leak in them so that the pump won't prime. I was someone had a tweak that would correct the problem. Thanks for your suggestions.
 
   / Deutz Hydaulics/Power steering #4  
You could have lost your prime due to an air leak. Replace the suction hose or tighten it some more.
 

Tractor & Equipment Auctions

Kivel Q.A Pallet Forks (A50121)
Kivel Q.A Pallet...
PENDING SELLER CONFIRMATION  READ BEFORE BIDDING (A52748)
PENDING SELLER...
2019 FORD F-250 (A52472)
2019 FORD F-250...
Kivel Pallet Forks (A50121)
Kivel Pallet Forks...
2013 Crane Carrier Co. Low Entry Loadmaster Excel-S 25 Yard Rear Loader Garbage Truck (A51692)
2013 Crane Carrier...
2007 Mercedes 4D (A50120)
2007 Mercedes 4D...
 
Top