hawk7
Bronze Member
Well, I was looking at the bottom of my blade today and I have worn it down into the bolts that hold the cutting edge on. I still have enough steel to re-drill the blade. I can use the origianl hole as they are 1/2 moon shaped now. It looks like the original set up had washers that were bent over and welded to the blade.
My question is how far should the cutting edge stick down past the bottom of the blade? Also if anyone has a newer blade and wouldnt mind taking some detailed pictures of the back of the blade down toward the bottom and a good side pic showing the cutting edge, That would be a big help.
THANK YOU.
My question is how far should the cutting edge stick down past the bottom of the blade? Also if anyone has a newer blade and wouldnt mind taking some detailed pictures of the back of the blade down toward the bottom and a good side pic showing the cutting edge, That would be a big help.
THANK YOU.
