Deere 4310 transmission controller problems

[todd 4440]

i am working on a 4310 i have replaced the transmissin controller it is a e-hydro with cruise control, the controller is sending 2.38 volts out of wire F-3 for the flywheel spd. sensor so I cut the wire in case of a feedback and the controller is still sending the same voltage. I have all my grounds they are good and clean, correct supply voltage, and the cruise, load match, and motion match switches are also operating correctly. I cant calibrate the controller with this problem the status ind. light is on steady. NEED HELP thank you

 

[aczlan]

I moved your post to the John Deere Owning and operating forum. You should get a better response here than in the "News and Feedback" forum.

Aaron Z

 

[joecdeere]

Todd, I don't know the answer, but I have a PDF of the tech manual you're welcome to if needed

Joe

shoot me your email if so

 

[mfreund]

Without knowing why you replaced the controller, I would guess the flywheel speed sensor is bad. There had been a few posts of bad flywheel sensors and at least one of the posters replaced his controller multiple times and turned out to be flywheel sensor.