My 4110's 3-pt hitch lever is acting up. It had been binding, but with some effort, I could always get it to move the full range. Today, I looked at the level and it was a bit twisted. I straightened it, (aka bent it back) but now it moves to the highest position ok but will not go lower than "5". If you look at the attached picture, the photo on the left shows the lever while it is at the "8" position, and "pt A" shows a bolt head in a slot. In the photo on the right, I moved the the lever as far down as it will go and it interferes with the bolt head at "pt B". In a way, it seems like the bolt may be intended to be a stop for the lever. But since the bolt is on a slot, and is as far forward as it can be, I am thinking it something is not right. I could bend the lever to clear the bolt head, but that doesn't seem right either.
Anyone have any thoughts? Thanks.
Bob
Anyone have any thoughts? Thanks.
Bob
