cylinder question

   / cylinder question #1  

hernando

Silver Member
Joined
Nov 17, 2003
Messages
249
Location
tennessee
Tractor
dk 4510 kioti and a 450 case track loader
i have to replace a cylinder on my backhoe ...overall lenght is 21'' retracted...extended shaft is 16'' does this make it a 16'' stroke ??? i know it should be simple .but it must my old age creeping in..i just cant think straight.... thanks for the help bruce
 
   / cylinder question #2  
With cylinder retracted, measure the distance from center of base mounting hole to shaft end mounting hole. Then extend the cylinder shaft until it stops. Measure from the center of the base pin to the center of the pin hole on the extended shaft. That will be your stroke.
 
   / cylinder question #3  
I thought you were supposed to subtract the retracted length from center of pin to pin from the extended length from center of pin to pin to get the amount of stroke. So if extended length is 60" from center to center and retracted is 44" from center to center, then the stroke would be 16".
 
   / cylinder question #4  
We are saying the same thing.
 
   / cylinder question
  • Thread Starter
#5  
thanks for the replys... i understand now,..thanks for all your help
 

Tractor & Equipment Auctions

1999 CHEVROLET C7500 UTILITY TRUCK (A53426)
1999 CHEVROLET...
2018 MDB T5E MDB DISC MOWER (A51247)
2018 MDB T5E MDB...
MURRAY 22" GAS PUSH MOWER (A51248)
MURRAY 22" GAS...
John Deere 6120E (A50323)
John Deere 6120E...
2019 KENWORTH T800 (A53843)
2019 KENWORTH T800...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
 
Top