suburbanfarmer
Silver Member
Hi All,
So we had a bit of snow and I used the loader to clear it up but quite a few times noticed that the curl function went weak or limp.
There is no oil leaking anywhere. I did the full raise and curl to get any air out but seems the functioning is intermittent at best. The dump is loud and seems to stick.
Thinking I need to get the cylinders rebuilt. Here is the problem on my JD2720 loader: I can see the nuts on one side but the other has a zerk fitting. I did multiple searches but there are no videos or posts on how to remove these cylinders.
So tomorrow morning I will remove the loader and then try loosening the nuts on the cylinder and go from there. Do I simply tap those bolts out of the loader which should free up the cylinder? Any help is appreciated if anyone has a write up or how to links.
I will not be doing the rebuild myself but taking it to a shop for repairing it. Will be getting the seal kits directly from JD.
So we had a bit of snow and I used the loader to clear it up but quite a few times noticed that the curl function went weak or limp.
There is no oil leaking anywhere. I did the full raise and curl to get any air out but seems the functioning is intermittent at best. The dump is loud and seems to stick.
Thinking I need to get the cylinders rebuilt. Here is the problem on my JD2720 loader: I can see the nuts on one side but the other has a zerk fitting. I did multiple searches but there are no videos or posts on how to remove these cylinders.
So tomorrow morning I will remove the loader and then try loosening the nuts on the cylinder and go from there. Do I simply tap those bolts out of the loader which should free up the cylinder? Any help is appreciated if anyone has a write up or how to links.
I will not be doing the rebuild myself but taking it to a shop for repairing it. Will be getting the seal kits directly from JD.