Cutting Torch Tips.

   / Cutting Torch Tips. #1  

EdKing

Platinum Member
Joined
Jan 28, 2002
Messages
851
Location
South West Pa/Greene county
Tractor
Long/Landtrac360DTC
I got a question for all you weldors out there. I just got a good deal on some cutting tips for my Oxy/Propane torches. I got 4 each size 4/0 and 5/0 tips and was wondering what the cutting capicity is for these size tips. I searched quite a bit on the net and couldn't find any info.

Thanks in advance,
 
   / Cutting Torch Tips. #2  
Ed
It depends on what manufacture made your tips. Check out this <A target="_blank" HREF=http://www.arcsmith.com/ntt/default.htm>SITE</A> . Their catalog list the different manufactures and thickness each tip will cut.
 
   / Cutting Torch Tips.
  • Thread Starter
#3  
Thanks Ron, I have a Harris torch. They list the 4/0 as 1/4", but not the 5/0. I guess it is just a little thinner capicity.
 

Tractor & Equipment Auctions

(INOP) CATERPILLAR 259D SKID STEER (A50459)
(INOP) CATERPILLAR...
2008 CATERPILLAR 304C CR EXCAVATOR (A51242)
2008 CATERPILLAR...
2014 CATERPILLAR 336FL EXCAVATOR (A51242)
2014 CATERPILLAR...
Harper SB1300 Straw Blower with Hose (A51039)
Harper SB1300...
2008 HONDA GOLDWING GL1800 TOURING MOTORCYCLE (A50505)
2008 HONDA...
2017 CHEVROLET 2500 HD (A50854)
2017 CHEVROLET...
 
Top