Curl Bucket Cylinder over extended on VTEK?

[Coldwater]

I think I am going to order from VN1(little more $$) to assure I get the correct cylinder but I thought I would post up the measurements I took off the one good one I have for posterity:

Stroke: 11 1/2"
Cylinder Diameter (not Bore): 1 15/16"
Rod Diameter: 1"
Retracted - Center of eye to center of eye: 20 1/8"
Extended - Center of eye to center of eye: 31 3/4"
Eye hole: 3/4"

Looks like Surplus center has a match with a 12" stroke. Part number 9-7270-12.

i like to see the rod diameters 1 1/8 and and eye hole 1" for a good loader.what did all this set you back$???

 

[Scotty Dive]

the new cylinder was $160. I could have gotten it cheaper but it would have been slightly off from the other stock one. The coldwater loaders have a single cylinder for the tilt right?

Someday I would like to beef it up with larger cylinders

 

[Coldwater]

the new cylinder was $160. I could have gotten it cheaper but it would have been slightly off from the other stock one. The coldwater loaders have a single cylinder for the tilt right?

Someday I would like to beef it up with larger cylinders

160 not bad.i seen loader cylinders go for a a lot more.