CTAndersom
New member
Needing help for a John Deere baler. I need to repair Flexco alligator rivet fasteners. Unable to remove pins
CTAndersom
- Thread starter CTAndersom
- Start date
- Views: 1177
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
:welcome:
:tractor: I'm going to move this thread over to our John Deere section for you.
:tractor: I'm going to move this thread over to our John Deere section for you.
mddorange
Elite Member
- Joined
- Jul 16, 2014
- Messages
- 3,357
- Location
- Guin, AL
- Tractor
- 2014 Kubota L3200 DT w/LA524 FEL, Loaded rear tires, LP RCR 1860 5' Cutter, LP RTA 1258 5' Tiller, LP PFL 2042 Pallet Forks w/60" Extensions, KK BB60 Box Blade, KK PHD-12" Post Hole Digger
:welcome:
To the TBN forum CT. Glad that you joined with us here. I am sure that someone will be able to help you.
Which side of Ashland are you on? I married a Baker girl from Lineville. Maybe you know Albert or Earl?
To the TBN forum CT. Glad that you joined with us here. I am sure that someone will be able to help you.
Which side of Ashland are you on? I married a Baker girl from Lineville. Maybe you know Albert or Earl?
Rara Avis
Veteran Member
Tx Jim
New Member
Welcome to TBN
Which pins are you referring to? The pin that keeps both halves of lacings connected or the pins that hold lacings to belts? If it's the one that hold lacings to belt correct method is to cut belt off just behind lacing then install new lacing utilizing the correct tool. Belt to be cut off square so belt will track straight
Which pins are you referring to? The pin that keeps both halves of lacings connected or the pins that hold lacings to belts? If it's the one that hold lacings to belt correct method is to cut belt off just behind lacing then install new lacing utilizing the correct tool. Belt to be cut off square so belt will track straight
