Hoffie
Member
What should it cost to have 2 hooks and a clevis welded on a FIL? I supplied the hardware.
Cost to weld hooks & clevis on FEL
- Thread starter Hoffie
- Start date
- Views: 3391
Sully2
Veteran Member
Those an a LONG piece of angle for additional support costs me a case of Corona's...Hoffie said:
crbr
Veteran Member
Shouldn't be too much. Nothing outrageous at all. I'd say if you can catch a welder on a job with a service truck or a local machine shop with the doors open and an empty shop, or a buddy..... should be reasonable of US$25 - US$50 maybe????Hoffie said:
A case of Corona is about US$25.00 or less...
Kubotasrking
Gold Member
Hoffie said:
What did they quote you?
A used stick welder is pretty cheap.
Kubotasrking
Gold Member
Hoffie said:
Sounds OK to me.
Cost has a high range. Some shops will just do it and send you on your way. The shop gets a long term customer and they don't have to do a bunch of paper work that probably costs them as much as the job!
Other shops may charge you for an hour of time. Assuming you bring the machine or bucket to them
If you want to minimize costs and have a good result, strip off the paint from the area you want the hooks and any supports added. Then clean up and repaint after it's attached.
For me, getting the stuff to a shop is about an hour's work each direction. It was cheaper to get a 255 amp mig welder. (That's my story and I'm sticking to it!!)
jb
Other shops may charge you for an hour of time. Assuming you bring the machine or bucket to them
If you want to minimize costs and have a good result, strip off the paint from the area you want the hooks and any supports added. Then clean up and repaint after it's attached.
For me, getting the stuff to a shop is about an hour's work each direction. It was cheaper to get a 255 amp mig welder. (That's my story and I'm sticking to it!!)
jb
Bill Barrett
Platinum Member
- Joined
- Jul 11, 2006
- Messages
- 670
- Location
- midwest
- Tractor
- Kubota L3130, Satoh G650, Case 580, Case 446
sounds cheap to me
weldingisfun
Veteran Member
- Joined
- Dec 12, 2006
- Messages
- 1,790
- Location
- West Bell County, Texas
- Tractor
- Mahindra 4500 4WD w/FEL, and Scotts S2048 lawn tractor
A reasonable quote. I don't think you are getting ripped off, if that is your concern.Hoffie said:
Wesdor
Gold Member
My dealer welded them on for free when I bought the tractor.
Now if you look through my posts, you will observe that I have a high opinion of the dealer - but that is only one small reason.
Now if you look through my posts, you will observe that I have a high opinion of the dealer - but that is only one small reason.
