Color Coding on GC Loader Valve

[dnw64]

I had a small leak in my valve so I took out the fittings and replaces the O-Rings, and forgot to note which one went where...

Of course it doesn't really matter which one goes where, but if the color coding from the zip ties is going to be helpful, it does make a difference.

Someone have a pic of their valve?

 

[irvingj]

Here's the way it is on my 2310, but keep in mind there have been some discrepancies in the colors occasionally from the dealer or factory....

This is standing in front of the tractor looking rearward.

 

[dnw64]

Thanks!

 

[DMW]

I don't think there is a "factory" colour code for the hoses. My GC2300 is a bit different.

The ports I posted are not the actual correct ones, just the closest to the couplings, so I deleted them, to avoid confusion.
The spool on the left side controls the lift arms, the spool on the right the curl function.

Direction can be changed by switching the connections curl rod/base, or the lift rod/base

 

[dnw64]

Hmmm. Ok. I guess I will just have to try it and see what happens

Problem is that I don't have anything attached right now so I won't know until I go to use it, and probably won't remember that it may be hooked up wrong!

:laughing:

 

[Jedidadx2]

Hi DNW,

I am on shift today, tomorrow when I get home I can take a picture of my connections for you if you still need reference. I have a 2017 gc1710. I"ll just have to figure out how to post a pic up.

 

[dnw64]

The spool on the left side controls the lift arms, the spool on the right the curl function.

That's probably the most helpful :thumbsup:

 

[AxleHub]

the manual has a pi ture and description of each of the couplers.

 

[WranglerX]

Here is diagram from GC 1705-1720 manual.... Don't know it its consistent with 2310 though....



Possible up grade color codes to put zip ties on both hoses and connectors (base) ?

Belkin Nylon Tie Wraps 4 Assorted Colors Pack Of 52 by Office Depot & OfficeMax

Dale

 

[pcwolf]

Mind helping a new guy? I also have a slight leak. Is there anything else inside the valve I can lose besides the O-ring?

I had copied this from another poster:

Tilt cyl rod: Red
Tilt cyl base: Blue
Lift cyl base: Green
Lift cyl rod: Yellow

-Phil