Forks Clamp on forks - finally got a set...

   / Clamp on forks - finally got a set... #11  
How tall are the forks, an inch, 2 inches?
 
   / Clamp on forks - finally got a set...
  • Thread Starter
#12  
How tall are the forks, an inch, 2 inches?

I'm not close to my tractor now so I can't just step out and measure it but....

the forks are made with the same tubing that the stake pockets are made from. So, if a piece of 2x4 lumber fits just inside it, the tubing is probably a little bit less than 2 1/2" x 4 1/2" on the outside dimensions.
 
   / Clamp on forks - finally got a set... #13  
Thanks for the measurement. I am trying to get under a hot tub but only have a 1 3/4" gap at best.
 
   / Clamp on forks - finally got a set... #14  
Thanks for the measurement. I am trying to get under a hot tub but only have a 1 3/4" gap at best.
If the hot tub is empty, you'll have no problems, it will raise right up(they aren't that heavy). I worked at a place where we plumbed them, then loaded by hand a took to the job site.
 
   / Clamp on forks - finally got a set... #15  
As a matter of fact, this brings back a memory.

We delivered a hot tub to a house, the guy looks at the guy I was with and says..............I've got a 4 foot sliding door, how ya gonna fit that 8 foot hot tub in there?.......


My buddy was speechless..........had no clue what to say.

The guy then asked me(cause I was snickering)........

I said........when we rounded the corner with the pick-up,...............I noticed hinges on the wall, if it were me..............I would just swing the walls open.

He had 2 ..........11 foot walls on hinges.......a 22 foot opening for an 8 foot hot tub:laughing::laughing::laughing:
 
   / Clamp on forks - finally got a set... #16  
Mine is sitting on a concrete slab and and needs centered up between a couple new poles that support the new roof over the tub. I drained the tub and 3 of us still couldn't get it to move. This one has jets in the center bottom coming from a sphere that must hold water. My other tub, you could at least scoot it around but not this one.
Funny thing is, I just had a guy move our lofted cabin and now the tub needs moved. Between the both of them, I could had bought the forks for what I will pay to have things moved.
 
 

Tractor & Equipment Auctions

4 1/2 150G DRILL STEM 288 JOINTS (A50854)
4 1/2 150G DRILL...
Pump Jack with Battery (A49461)
Pump Jack with...
2000 Ford F-650 TMA Attenuator Truck (A49461)
2000 Ford F-650...
John Deere Gator XUV835M 4X4 Utility Cart (A48082)
John Deere Gator...
2016 Ford F550 4x4 Bucket Truck with Altec AT41 - 46FT Rotating Bucket and Jib Winch (A51039)
2016 Ford F550 4x4...
RoGator 844 sprayer (A50490)
RoGator 844...
 
Top