jenkinsph
Super Star Member
Joe,
For my work I may need to make tight orbits between borders or terrace rows which would amount to lots of constant turning. What I am building up is a Gannon boxblade which will be used with both a 3ph setup for roughing in much like a Level Best arrangement and a tow type arrangement for finish grading. I need to be prepared for the tight turns and straight runs depending on the job at hand.
I am definitely considering adding a rear roller to my landplane much like the picture you referenced. Brian and I have kicked this around.
For my work I may need to make tight orbits between borders or terrace rows which would amount to lots of constant turning. What I am building up is a Gannon boxblade which will be used with both a 3ph setup for roughing in much like a Level Best arrangement and a tow type arrangement for finish grading. I need to be prepared for the tight turns and straight runs depending on the job at hand.
I am definitely considering adding a rear roller to my landplane much like the picture you referenced. Brian and I have kicked this around.