ArlyA
Super Star Member
- Joined
- Mar 18, 2016
- Messages
- 14,098
- Tractor
- Outlander1000 6x6, Ego lawn mower and shopping for tractor
Following this thread
https://www.tractorbynet.com/forums/build-yourself/410025-help-v-belt-sizing.html
I'm assembling plans for a snow tiller which needs drive case at its end, as seen in the below photo. This is a very simple design, with a bit of heavy gear oil at its bottom to lube the single chain, least if it would stay in the case! The 1, 1/4 input shaft with run at about 3000rpm and there are no seals on the shafts, just what's on the bearings to start with. Of course this would have a drain and a full indicator plug, for the oil at the case bottom and another its it top to add it.. Just a little at the bottom would be used. What do you think?? The input shaft with have 35hp on it so what chain size should be sufficient?
I'm not a ME and I don't play one on YouTube....
https://www.tractorbynet.com/forums/build-yourself/410025-help-v-belt-sizing.html
I'm assembling plans for a snow tiller which needs drive case at its end, as seen in the below photo. This is a very simple design, with a bit of heavy gear oil at its bottom to lube the single chain, least if it would stay in the case! The 1, 1/4 input shaft with run at about 3000rpm and there are no seals on the shafts, just what's on the bearings to start with. Of course this would have a drain and a full indicator plug, for the oil at the case bottom and another its it top to add it.. Just a little at the bottom would be used. What do you think?? The input shaft with have 35hp on it so what chain size should be sufficient?
I'm not a ME and I don't play one on YouTube....
