Rickj1972
New member
- Joined
- Feb 20, 2023
- Messages
- 2
- Tractor
- 950B cat wheel loader
Why is it pushing all the oil out the vent tube
Cat 950B wheel loader
- Thread starter Rickj1972
- Start date
- Views: 1652
OP
Rickj1972
New member
- Joined
- Feb 20, 2023
- Messages
- 2
- Tractor
- 950B cat wheel loader
On the gear box
crashz
Elite Member
Gonna need a lot more info. What conditions does this happen? Assume correct fluid levels? Does the loader have all gears and power in each? Does it do it only when hot, pushing hard or all the time? When was it serviced last?
My first thoughts are - overfilled, overheated, or a clogged passage/filter.
My fathers was a D (I think) and if I recall correctly had an air over hydraulic brake system and trans disconnect. Air pressure was required to shift. We had troubles with the air brakes all of the time (not uncommon) which seemed to lead to the loss of gears. For many years we ran it with 2nd gear only until that finally gave out too. Rebuilt to the tune of $25k.
My first thoughts are - overfilled, overheated, or a clogged passage/filter.
My fathers was a D (I think) and if I recall correctly had an air over hydraulic brake system and trans disconnect. Air pressure was required to shift. We had troubles with the air brakes all of the time (not uncommon) which seemed to lead to the loss of gears. For many years we ran it with 2nd gear only until that finally gave out too. Rebuilt to the tune of $25k.
Here are some similar links:
