Case 480E Box Blade question

   / Case 480E Box Blade question #1  

dlbraly

New member
Joined
May 7, 2024
Messages
16
Location
Texas
Tractor
Case 480E LL
Looking to find a seal kit for a hydraulic actuator, but Not sure which one to pick in the Parts Catalog.
What is the cylinder called that tilts the box blade front to rear (Not side to side or up and down).
Circled the one I mean in the picture.

I bought this tractor like this, the way the lines are routed they rub each other and parts of the tractor.
Can someone share a picture of what theirs looks like or an image of how to clean it up?

Case480Cylinder.jpg
 
   / Case 480E Box Blade question #2  
It's called a top cylinder or pitch cylinder. Case calls it a pitch cylinder. The cylinder number is stamped on the top of the gland nut.

For G33128 THREE-POINT HITCH PITCH CYLINDER, FOR CATEGORY I HITCH W/3/4'' DIA. MOUNTING PINS, Kit G109476

For 1976884C1 THREE-POINT HITCH PITCH CYLINDER, FOR CATEGORY I-II HITCH W/1'' DIA. MOUNTING PINS, Kir G110055

As far as the hoses go, loosen them up on bothe ends and get them to lay flat. After that, you may need to take one end off and reroute.
I've worked on a couple, but none nearby.
 
   / Case 480E Box Blade question
  • Thread Starter
#3  
Thanks for you help and advise.
PITCH CYLINDER.jpg
 

Tractor & Equipment Auctions

Bron V75-3 Pull-Behind Hydraulic Vibratory Utility Plow (A49461)
Bron V75-3...
2015 SkyJack SJ86T 4x4 86ft Telescopic Boom Lift (A49461)
2015 SkyJack SJ86T...
Agco 8200 Flex Grain Platform (A50514)
Agco 8200 Flex...
2019 NEW HOLLAND TS6.130 TRACTOR (A51406)
2019 NEW HOLLAND...
New 4x6 Chicken Coop (A50774)
New 4x6 Chicken...
2007 John Deere TX 4x2 Utility Gator (A49346)
2007 John Deere TX...
 
Top