Jerry/MT
Elite Member
- Joined
- Feb 2, 2008
- Messages
- 3,141
- Location
- North Idaho-The Palouse
- Tractor
- New Holland TD95D, Ford 4610 & Kubota M4500
RichB,
It pretty obvious to me that my TD95D has hydraulic brake actuation (2 master cylinders and a brake fluid reservior). Unfortunatley my official NH service manual's Brake Section (Section 33) shows mechanical brakes. My owner's manual refers to a hydraulic system but the trouble shooting guide says "see dealer".
How can I get the right section in the manual for dealing with any brake issue?
The unit has 270 hours on it and I know the brakes are not worn out. The pedal goes almost to the floor and if you pump the pedal, the pedal comes up so it either has a leak (no signs of fluid dripping) or it was never filled properly and bled, etc and has some air in the system. Rather than climb under it and figure out where the bleeders are at, I'd like to have the correct section of the shop manual so I can understand the system and fix the issue.
Is ther any advice you can give me on how to get the proper section of the manual and/or where I can find a good system schematic so I can bleed the system?
Thanks in advance
It pretty obvious to me that my TD95D has hydraulic brake actuation (2 master cylinders and a brake fluid reservior). Unfortunatley my official NH service manual's Brake Section (Section 33) shows mechanical brakes. My owner's manual refers to a hydraulic system but the trouble shooting guide says "see dealer".
How can I get the right section in the manual for dealing with any brake issue?
The unit has 270 hours on it and I know the brakes are not worn out. The pedal goes almost to the floor and if you pump the pedal, the pedal comes up so it either has a leak (no signs of fluid dripping) or it was never filled properly and bled, etc and has some air in the system. Rather than climb under it and figure out where the bleeders are at, I'd like to have the correct section of the shop manual so I can understand the system and fix the issue.
Is ther any advice you can give me on how to get the proper section of the manual and/or where I can find a good system schematic so I can bleed the system?
Thanks in advance