Cable Tie Holder

[BravoXray]

For years I have had several bags of cable ties of varying sizes hanging on the back of my toolbox. It was always a pain to dig a few out of the bags without the hook that they hung from ending up on the floor.
Sooo, I drew up a six tubed holder in Tinkercad and 3D printed it and a hook that will hang it off the back of the toolbox. Actually, this is the second one I printed, as the first one really wasn't large enough to hold a decent number of cable ties.
The tubes are 50mm(2") in diameter, and 100mm(4"), 150mm(6") and 200mm(8") tall.
A great improvement.

 

[MoKelly]

Pretty cool.

And I thought I had lots of zip ties! You got me beat.

MoKelly

 

[jaxs]

Clever,might be even handier if bottom of all tubes were even so that tie liengths would be more obovious.