BX2350 CCM Top Link

[crossfire190]

The replacement cylinder is 14" to 20". After installing the 90's I don't have any problem at all with the hose interference. My problem was with my quick hitch which comes up pretty close to the ports when the 3pt is fully raised.

 

[newtattoobob]

I know this is an old thread but I am thinking about adding top and tilt to my BX, and I was wondering if you have been happy so far with the ccm cylinder and how expensive are the cylinders? Thanks Bob

 

[CHDinCT]

I know this is an old thread but I am thinking about adding top and tilt to my BX, and I was wondering if you have been happy so far with the ccm cylinder and how expensive are the cylinders? Thanks Bob

I priced the top link about two months ago for my BX at $180 or $185 plus shipping. I think it came to a little over $200. My understanding is the side links are more expensive as they're more custom. I went with a swivel eye top link cylinder from Surplus Center for under $100. I'm sure not the quality of a CCM cylinder and no check valves, but for what I use it for, it's fine.

 

[crossfire190]

I know this is an old thread but I am thinking about adding top and tilt to my BX, and I was wondering if you have been happy so far with the ccm cylinder and how expensive are the cylinders? Thanks Bob

The CCM cylinder was right around $190.00 - I can't recall for sure.

After I got the leak stopped by tightening the fittings the cylinder has worked great. I have had a set of forks built to fit on my 3pt and the lift capacity of the 3pt was maxed when i was trying to move pallets of firewood. Now, I lift as high as possible with the 3pt, then use the toplink to tilt a bit more, that gets me enough ground clearance to move about.
I would highly recommend CCM.

 

[ptrotter]

I just received a top link from CCM for my B7800. It looks very good and works well. They are nice people although a bit disorganized. There is only one person, Mark, who deals in top links and he is somewhat hard to reach but when you get him he is very knowlegable and helpful. Right now it seems they are very busy with haying equipment so it may take a few days to get stuff from them.

Paul

 

[newtattoobob]

Thanks, I guess I will give CCM a call sometime this week.