BX2000 FEL Fast dump problem

[DaveNH]

It just up and quick working.
Worked fine last time I used it - a couple of weeks ago.
Today I went to do some work and it won't even click over.
Even after an hour of use the value won't go to fast dump.
I disconnected all the lines and reconnected them making sure they were tight.
Lines are warm so there is fluid pumping through them.
Slow dump works but it's too slow when moving snow.
Float, up, down, curl and slow dump work ok, it 's just the fast dump
that isn't.

Any sugguestions? /forums/images/graemlins/confused.gif

 

[Junkman]

Re: BX2200 FEL Fast dump problem

Mine did this also, and I found that I had to disconnect and reconnect the quick disconnects to cure the problem. Make sure that they are fully plugged in and that you relieve all pressure before disconnecting them and reconnecting them. I believe that something is hanging up in the valve mechanism after this happening to me 3 different times. Might be interesting to compare serial numbers of the valve to see if there is a possible manufacturing defect that is causing this.... Mine is a 4 way valve on a BX-22... I posted about this problem this past summer..... /forums/images/graemlins/frown.gif