Broke Clutch Bellhousing
- Thread starter dsgbraves
- Start date
- Views: 5042
California
Super Star Member
- Joined
- Jan 22, 2004
- Messages
- 15,001
- Location
- An hour north of San Francisco
- Tractor
- Yanmar YM240 Yanmar YM186D
Welcome!
How the heck did that break?
How the heck did that break?
Neat 1500
Platinum Member
Mmm not good. i suspect you will have to get it welded up as a replacement maybe extremely difficult to find. do you have a FEL on your 1810?
deepNdirt
Veteran Member
Ha! Neat 1500. this was the first thing went through my mind as well,
isn't the 1810 US version? if there is a crossover for the gray, might be a better chance finding one, ( Parts tractors ) over sea,Oh yeah! I would welcome you there dsgbraves but it looks like you already been a member for a few years,
with nothing to say
clemsonfor
Super Member
Hoye? coldwater?
California
Super Star Member
- Joined
- Jan 22, 2004
- Messages
- 15,001
- Location
- An hour north of San Francisco
- Tractor
- Yanmar YM240 Yanmar YM186D
That's a Japan-market model, not a US model.
Where's Leonard? He used to respond to this sort of request. Inquire at
Sheaffer's Town & Country Tractor
He knows contacts in Japan who can find anything. Prepare to pay for this specialized service.
Where's Leonard? He used to respond to this sort of request. Inquire at
Sheaffer's Town & Country Tractor
He knows contacts in Japan who can find anything. Prepare to pay for this specialized service.
There is one out there sitting in some yard somewhere just finding it is the challenge.
A good welder could do it justice but if its being used with a loader he will have to add some decent load bearing braces to prevent a recurrence. That may well be what caused the failure anyway if none are on there now.
A good welder could do it justice but if its being used with a loader he will have to add some decent load bearing braces to prevent a recurrence. That may well be what caused the failure anyway if none are on there now.
California
Super Star Member
- Joined
- Jan 22, 2004
- Messages
- 15,001
- Location
- An hour north of San Francisco
- Tractor
- Yanmar YM240 Yanmar YM186D
Bulldog or V2 loader?
Did this have the recommended loader subframe tied to the rear axle?
Did this have the recommended loader subframe tied to the rear axle?
deepNdirt
Veteran Member
I thought it might have been,
I wonder if the same housing is use for any other YM CUT models in similar size? Is there any No# to be found on it?