Block Heaters 24/7

   / Block Heaters 24/7 #11  
When my dealer delivered my new tractor, his instructions were to only plug the block heater in for a hour before trying to start the tractor. The heaters don't have a thermostat and run non-stop. No need to overdo it. Just sayin.

Ahh, but they do!
 
   / Block Heaters 24/7 #12  
I monitored block temps years ago on my Kubota L3410 with a 400w block heater. Running the block heater longer than 3 hours did not result in higher block temps in 0-32 degree ambient temps. The block was always getting warmer at less than 3 hours, and for shorter than an hour the block temps were not at all even at various points.
If I may be doing a snow route in the morning I have the block heater come on at 3-4 hours prior to starting. I use a programmable smart plug that I schedule in advance.
 
   / Block Heaters 24/7 #13  
With most block heaters being 600 watts or less that would be around 14.4 Kw per day.
So if your electricity is $0.16 per Kw that would be about $2.30 per day, or around $70 per month.
So is it worth it to plug it in all the time, I guess it depends on how often you need it and if you want to wait for it.

Now some of the newer and larger tractors with block heaters and hydraulic heaters will be closer to 1500 watt,
so that will add up faster, of course if you are using it 6 hours as day that will add up also.
Yes thanks for figuring out exactly how much it might cost, way to much money for me to waste . Retired so it’s usually really no problem to plug the tractor in for a couple hours before using it.
A couple hours pre-heat is enough,just a waste any longer.Buy a heavy duty timer.I leave a battery tender on mine all the time in cold weather and switch to the block heater a couple hours before use.
Farmer's electricity is paid by "the farm" so they don't care.
So you for some reason believe farmers don’t care about the cost of electricity ? My guess would be that a farmer that doesn’t care about the cost of electricity probably isn’t a very successful farmer.
 
   / Block Heaters 24/7 #14  
I've been using mine in the truck and the tractor for about an hour before I turn the key. Seems to be enough, but I'm not parked outside at 0 degrees either.
 
   / Block Heaters 24/7 #15  
Smart plugs are the way to go for a block heater! I have my truck on one and have it set to come on when below a set temperature and during a set time frame in the AM. If I need another time, I open the app and turn on the plug! Sure beats coming on every morning if not below temperature!
 
   / Block Heaters 24/7 #16  
I monitored block temps years ago on my Kubota L3410 with a 400w block heater. Running the block heater longer than 3 hours did not result in higher block temps in 0-32 degree ambient temps. The block was always getting warmer at less than 3 hours, and for shorter than an hour the block temps were not at all even at various points.
If I may be doing a snow route in the morning I have the block heater come on at 3-4 hours prior to starting. I use a programmable smart plug that I schedule in advance.

I haven't monitored mine with the temperature gauge in years now. I do know that the difference in engine temperature when I touch the off side of the engine block is noticible after 3 hrs but and not after one hour. At 10F, in the little Kubota this is enough time that it will start and run smoothly. The JD engine is three times the size, and it likes an extra hour or more.

Both tractors use the same same standard block heater that threads into the side of the block. Both are 115volt at 3.17 amps = 365 watts. Our electrical rate is slightly less than 10 cents a kWHr. so heating the tractor up costs a dime. Cheap insurance.

BTW, most tractors incorporate a coolant bypass in case of a stuck thermostat. Two ways I've seen are either a drilled hole in the thermostat itself or passage built into the thermostat housing. That's true of both the Kubota and the JD. That bypass allows coolant to thermosiphon between the radiator and engine block to protect against overheating. Given some way to bypass the thermostat, the only requirements for thermosiphoning circulation to work is that the system be full of coolant and the tractor sitting relatively level.

I assume that all tractors (& all engines for that matter) have a similar coolant bypass, but do not know that for sure.
rScotty
 
   / Block Heaters 24/7 #17  
Let's not forget that block heaters have a finite service life.
Leaving it plugged in all the time will shorten it's life and,perhaps,fail at the worst possible moment.
 
   / Block Heaters 24/7 #18  
Well they are never going to fail when you don't need it...
 
   / Block Heaters 24/7 #19  
I have a Katt inline heater on my Iseki 3160, I have it on a remote switch so I don't have to go outside if it's bad out to plug it in. I'll turn it on a couple of hours before going out which works fine for me. I could leave it plugged in as it does have a thermostat but I can't see the sense in it, not to mention the cost, it definitely makes a difference in starting........Mike
 
   / Block Heaters 24/7 #20  
I have heater wire to time clock with bypass works fine over the years.
 

Tractor & Equipment Auctions

2000 KOMATSU VALMET 860.4 FORWARDER (A51222)
2000 KOMATSU...
2008 International 8600 T/A Day Cab Truck Tractor (A48081)
2008 International...
HUSKY 135 PSI AIR COMPRESSOR (A50854)
HUSKY 135 PSI AIR...
2018 INTERNATIONAL LT625 SLEEPER (A51219)
2018 INTERNATIONAL...
2016 John Deere TS Gator Utility Cart (A48082)
2016 John Deere TS...
P&H OMEGA 20-20 (A50854)
P&H OMEGA 20-20...
 
Top