goeduck
Super Member
Let Big Barn Bird Fly!!! Always a fan !
Big Barn’s Retirement Farm Shop
- Thread starter Big Barn
- Start date
- Views: 815352
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Table top for hydraulic lift table framed in with 1/8"x2x2 angle iron
drivesitfar
Silver Member
Love the lift and is that the only modification or are there more to come?
I think spring is finally here so looking forward to sunshine and some heat soon.
I think spring is finally here so looking forward to sunshine and some heat soon.
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
I modified some sliding arm F clamps for the 1 3/8"D holes on my round welding table
And it worked well replacing a broken 1" pivot pin for my neighbor's 2x20' sprayer boom
And it worked well replacing a broken 1" pivot pin for my neighbor's 2x20' sprayer boom
OP
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Modified another pair with 1 5/8" pins for the cast iron platen while I was at it
used a cut off portion of a clamp to use as a hanger....
used a cut off portion of a clamp to use as a hanger....
dragoneggs
Super Star Member
- Joined
- Jun 9, 2013
- Messages
- 13,627
- Location
- Seabeck, Washington
- Tractor
- Kubota BX-25D, Kubota Z122RKW-42
That hanger has the cool factor!
