Bh77 bucket removal

[thunder86]

I'm looking at purchasing a bh77, 16" bucket and ripper. How hard is it to switch between these? I was going to get the quick attach for the backhoe but my dealer said it's fairly easy to switch them out but I cannot find any videos of anyone doing it. Thanks.

 

[4570Man]

With quick attach it’s a 1 minute or less job. With pins that’s not that bad but not fun either. I’d say it probably takes 10 minutes maybe less if you’re good at it.

 

[thunder86]

With quick attach it’s a 1 minute or less job. With pins that’s not that bad but not fun either. I’d say it probably takes 10 minutes maybe less if you’re good at it.

Thank you.

 

[fried1765]

With quick attach it’s a 1 minute or less job. With pins that’s not that bad but not fun either. I’d say it probably takes 10 minutes maybe less if you’re good at it.

Quick attach is the ONLY way to go!
Much easier to align!

 

[Aquamoose]

Where would you find a quick attach anyway?

 

[thunder86]

Where would you find a quick attach anyway?

Bxexpanded makes one. They make the ripper too.

 

[Aquamoose]

The site don’t list the Branson. I’ve inquired in the past if they would fit the Brandons by asking if they would verify by cross checking with my detailed & clear measurements. No response. Have any of you bought any for your Branson? Mine’s a BH76.