Bent valve cover

   / Bent valve cover #31  
"Also, it looks like the crack appeared on the outside of the cover."

The crack was through before I started.
Then it should be soldered too. Grind or wire brush the crack area about 3/8" on either side of the crack. Then solder. The solder should tend to flatten out at the edges. If it does then you know it is wetting the aluminum well.
Eric
 
   / Bent valve cover
  • Thread Starter
#32  
An update: I had time yesterday to top up the oil and run the engine for about 15 minutes. I seemed to have stopped the leaking, at least for the time being. I realize my repair could fail at any time so I will keep my eyes open for a replacement cover.
 
   / Bent valve cover #33  
An update: I had time yesterday to top up the oil and run the engine for about 15 minutes. I seemed to have stopped the leaking, at least for the time being. I realize my repair could fail at any time so I will keep my eyes open for a replacement cover.
Thanks for the update and good for you! I know everybody here truly appreciates the update. And the fact that you fixed it yourself not only adds to your confidence but also helps other folks who may be considering a similar repair. The repair doesn't need to be a valve cover, just an aluminum casting. And you just fixed yours! Even though I criticized your soldering job you showed me up by having a successful repair.
Cheers,
Eric
 

Tractor & Equipment Auctions

2003 Big Tex 10PI 16ft. T/A Pipe Top Utility Trailer (A49461)
2003 Big Tex 10PI...
2018 FREIGHTLINER CASCADIA TANDEM AXLE SLEEPER (A51222)
2018 FREIGHTLINER...
2014 Volkswagen Jetta Sedan (A50324)
2014 Volkswagen...
2015 JOHN DEERE 5100M TRACTOR (A51243)
2015 JOHN DEERE...
2019 TAEKUCHI TL8 SKID STEER (A51242)
2019 TAEKUCHI TL8...
2014 VOLVO VHD DAYCAB (A50854)
2014 VOLVO VHD...
 
Top