B7500 Wheel Width

[Steuben]

Hi, I just picked up a slightly used B7500 and was curious as to what was the wheel width most people have them set at. I'm new to tractors and would appreciate any help and advice from the experienced. Thank you.

 

[kevinj]

Hi, I just picked up a slightly used B7500 and was curious as to what was the wheel width most people have them set at. I'm new to tractors and would appreciate any help and advice from the experienced. Thank you.

Do you have a loader ??? What type of tires ????

PS It helps if you fill in your profile a bit.

 

[Steuben]

Thanks for the response, just bought the tractor and I registered before trying to figure tractor stuff first then I'll tackle profile. I have Ag tires and a 302 loader.

 

[Steuben]

Thanks for the response, just bought the tractor and I registered before ,trying to figure tractor stuff first then I'll tackle profile. I have Ag tires and a 302 loader. Check that, profile worked.

 

[Dan239]

My rear wheel are set wide for stability, I have the same tractor and loader.

Daniel

 

[don716]

When I bought my B7500 the wheels were all the way out. I moved them in one hole on each side. After putting my MMM on there it was just right. I have R-4 tires on mine. These are tough little tractors.I'm on mine almost daily.
Donny

 

[don716]

Steuben, Where are you from?
Donny

 

[Steuben]

Don, I'm from NY about 70 miles north of NYC but don't hold it against me.

 

[kevinj]

Thanks for the response, just bought the tractor and I registered before trying to figure tractor stuff first then I'll tackle profile. I have Ag tires and a 302 loader.

I would have to look at the manual but I would set them to be 48" outside measurement so they are as wide as the bucket. There are sveral combinations of wheel in/out and or hub in/out as well as the axle positions.

 

[spoon059]

I am contemplating a b7500 at a foreclosure auction, but it's a little narrower then my current b9200. How wide can the rear wheels be placed without modification? How wide can they be placed without modification? I have some steep angles that I mow on, and am concerned about the instability of a narrow tractor. Thanks for your help!