Gomez
Gold Member
I was hoping to be able to keep the MMM attached if I needed to install the backhoe (Woods BH65) for a small job.
One problem I'm having is the deck can not lift to the height required to insert the holdup pin.
The left side of the deck is fine, but the right side interferes with the bottom of the sub-frame (mower discharge tunnel).
I tried moving up the sub-frame bracket but still need another 1/4" or so.
The current access to install the holdup pins is less than easy with the FEL and BH sub-frames.
I was thinking of welding a piece of angle to the deck that would allow it to be pinned up to the bottom of the sub-frame where it clamps onto the FEL bracket.
I'm open to any other suggestions.
Thanks!
One problem I'm having is the deck can not lift to the height required to insert the holdup pin.
The left side of the deck is fine, but the right side interferes with the bottom of the sub-frame (mower discharge tunnel).
I tried moving up the sub-frame bracket but still need another 1/4" or so.
The current access to install the holdup pins is less than easy with the FEL and BH sub-frames.
I was thinking of welding a piece of angle to the deck that would allow it to be pinned up to the bottom of the sub-frame where it clamps onto the FEL bracket.
I'm open to any other suggestions.
Thanks!
