I need a wee bit of clarification with regards to a B20 Range Selector operation.
I understand the "U" pattern, starting with High range in the upper right position, down through a neutral, into Mid range at the base of the "U", and now here is the question. From the Mid range position I take it the pin on the lever is supposed to slid into a second lever below the surface of the cover, and from this point the second and first lever progress forward to the second neutral, and then forward to low range.
I just want to confirm that this is the correct operation as I appear to be able to slide the lever forward towards Low without engaging the second lever via the pin. (or now that I'm back in the house am I just thinking I did......???)
Thanks in advance!
Mike In Ont
I understand the "U" pattern, starting with High range in the upper right position, down through a neutral, into Mid range at the base of the "U", and now here is the question. From the Mid range position I take it the pin on the lever is supposed to slid into a second lever below the surface of the cover, and from this point the second and first lever progress forward to the second neutral, and then forward to low range.
I just want to confirm that this is the correct operation as I appear to be able to slide the lever forward towards Low without engaging the second lever via the pin. (or now that I'm back in the house am I just thinking I did......???)
Thanks in advance!
Mike In Ont