Armrest in l4060

[coupman35]

Ok is it me or seem like my armrest in my l4060 are to low , am 6 ft and look like the armrest are not usefull at all. My arm dont even rest on them there like 5 inch to low .Has any one try yo make some riser for them or some thing too get them a bit hier .Are all the seat the same .

 

[RjCorazza]

I'm just under 6' and find the armrest height about right. I rarely keep the left armrest down, but use the right side a lot, particularly for loader work.
Unfortunately they don't seem to be adjustable. I looked at the parts breakdown, and it looks like the armrests are not sold separate from the $900 seat... So don't mess them up if you decide to Fab something!

 

[coupman35]

Hum i had a look at it and ill think it over before i mess whit it .I love to frab stuff see what i can come up whit or not .

 

[johnnyvol]

I keep my left one up all the time too. I use the right one with the loader and as a shield to keep my elbow from hitting the pto switch while cutting.

 

[JethroB]

I keep my left one up all the time too. I use the right one with the loader and as a shield to keep my elbow from hitting the pto switch while cutting.

Yes that PTO switch is in a pesky place. Awkward to reach but my right elbow sure has no trouble finding it.

I suppose the armrests are a bit low. Maybe adding padding in some manner on top would be easier.

 

[coupman35]

After looking at it and pulling the armrest off i can make a braket but will have to cut the plastic but dont like that .I will at other way to do this .