Here is a picture of the plasma cutting setup. I built it so that I can pick it up with the forks on my loader and then either put it into the back of the truck, or just set it down where I want to work. It transports really easily like this, and I can put it away safe and sound in the shop when I am done. I might get around to building one out of steel someday, but for now this is serving me pretty well. The welder is a Miller Trailblazer 301G, the Plasma Cutter is a Miller Cutmate 375 and the compressor is a 4HP Porter Cable sidestack model. I added 100' leads to the welder, changed the plasma cutter over to a 220V plug, and changed the ground clamp out on the plasma cutter to be one I could put on pipe. This works neater than sliced bread for saddling pipe fence posts. I can't take all the credit for this setup though, like many ideas here on this message board, parts of the plan came from w_harv.