I have an Allied 380 loader, when I tilt the bucket all the way down and drag backwards, the bucket does not maintain position. If I hold the control handle down it will pressure up and hold in the down position. Same thing happens when I try to dig with the bucket, wont stay down unless I hold the control down while digging. Just changed the control valve, didn't help that problem. Any suggestions would be appreciated. Joe
Allied Loader question
- Thread starter Smokin50
- Start date
- Views: 3065
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Are you sure the valve lever is going back to neutral, and shutting off the flow to the cyl.
Do you have float?
Do you have float?
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,952
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
When you push the lever fwd all the way, does it detent, and stay in place. Does the bucket float on the ground rising and falling with the lay of the land?
Most tractor loader valves will have float.
When you set the bucket, either up or down, it should stay set until you move the valve lever.
You should be able to raise the front wheels off the ground using down force, and remain there for a good while.
Most tractor loader valves will have float.
When you set the bucket, either up or down, it should stay set until you move the valve lever.
You should be able to raise the front wheels off the ground using down force, and remain there for a good while.
