fbagg
New member
Any clues on how to get the nut out? I have bent the depressed area, that is serving as a lock, back but there is no room for a wrench and the shaft is 6" long so there is no socket that will reach.
Agco ST30X front axle disassembly
- Thread starter fbagg
- Start date
- Views: 2379
Any clues on how to get the nut out? I have bent the depressed area, that is serving as a lock, back but there is no room for a wrench and the shaft is 6" long so there is no socket that will reach.
Kernopelli
Veteran Member
- Joined
- Oct 16, 2006
- Messages
- 2,210
- Location
- Carterville, Illinois
- Tractor
- Mitsubishi MTE2000D, Dig It 258 Mini Ex, Deere Z930A ZTR
I don't know if a parts diagram would help but AGCO Parts Books ( enter as Guest) has them.
You may have to make a tool. Might be an expensive sacrifice to what appears will take a large socket but you could cut the drive end off a socket so it fits over the shaft and weld a handle to it. If the socket is tall enough, you may be able to simply turn it with vice grips or pipe wrench and not have to weld a handle to it..
You may have to make a tool. Might be an expensive sacrifice to what appears will take a large socket but you could cut the drive end off a socket so it fits over the shaft and weld a handle to it. If the socket is tall enough, you may be able to simply turn it with vice grips or pipe wrench and not have to weld a handle to it..
OP
fbagg
New member
Thanks Darryl got the picture, and good idea on the socket, if no one comes up with anything better that's probably what I will have to do.
