Buying Advice Agco GT75

/ Agco GT75 #1  

cooperman

New member
Joined
Dec 1, 2008
Messages
24
Location
Wilton,Ca.
Tractor
Cat D4, Ford 6610, JD 990 and Agco GT 75
Does anyone have any information about this tractor?
 
/ Agco GT75
  • Thread Starter
#3  
/ Agco GT75 #4  
Does it shift hard after it has sat quite a while? OR all the time?

I think one of my AGCO's has the same tranny, and when it sits quite a while, it shifts harder until it get's used a little.

I believe a little rust forms and after the shifter is used a bit, it wears away...

SR
 
/ Agco GT75
  • Thread Starter
#5  
Does it shift hard after it has sat quite a while? OR all the time?

I think one of my AGCO's has the same tranny, and when it sits quite a while, it shifts harder until it get's used a little.

I believe a little rust forms and after the shifter is used a bit, it wears away...

SR
I just recently went to see the tractor and yes it has been unused for quite some time. I was wondering if the clutch could be an issue, even with the low hours a clutch on the wrong foot can be a disaster.
 
/ Agco GT75 #6  
I'm betting it's the rust issue...

I'm thinking you can rule the clutch out, by trying to shift it with the motor off... IF it shifts hard then, you know it isn't the clutch.

After sitting a while, the lever just get's hard to move smoothly....

I think my "range" lever shifts harder IF it sets a time, too.

SR
 
/ Agco GT75
  • Thread Starter
#7  
I just bought the tractor for $19,000. I have my fingers crossed.
 
/ Agco GT75 #8  
Good for you! They are a pretty nice tractor that make good power for their size...

SR
 

Marketplace Items

KUBOTA MI08S TRACTOR (A63276)
KUBOTA MI08S...
KUBOTA MX6000 TRACTOR (A63290)
KUBOTA MX6000...
EZ-GO SHUTTLE 2X2 TXT GAS GOLF CART (A63276)
EZ-GO SHUTTLE 2X2...
2013 Kuhn Krause 80-40 Vertical Tillage Tool (A63116)
2013 Kuhn Krause...
PALLET LOT OF MISC TUBING (A63745)
PALLET LOT OF MISC...
2012 FREIGHTLINER 114SD ROLLOFF TRUCK (A59909)
2012 FREIGHTLINER...
 
Top