Adding intermittent wipers to a CK4020SE (or any cab model)
- Thread starter Bill_B
- Start date
- Views: 5376
SwingOak
Silver Member
- Joined
- Jan 31, 2011
- Messages
- 238
- Tractor
- '65 IH Cub Lo-Boy, '13 Kioti DK50SE HST, '20 Kioti RX7320
OK so the "Long" time of the delay isn't as long as I thought, turns out I'm just impatient...
The minimum delay time is about 1/2 a second, and the max delay time is 40 seconds.
I've also decided I'm going to add a small momentary NO pushbutton for both front and rear wipers, which will work just like the "mist" function on most cars. For some reason I find it annoying to have to turn a switch on & off just to cycle the wipers one time.
The minimum delay time is about 1/2 a second, and the max delay time is 40 seconds.
I've also decided I'm going to add a small momentary NO pushbutton for both front and rear wipers, which will work just like the "mist" function on most cars. For some reason I find it annoying to have to turn a switch on & off just to cycle the wipers one time.
SwingOak
Silver Member
- Joined
- Jan 31, 2011
- Messages
- 238
- Tractor
- '65 IH Cub Lo-Boy, '13 Kioti DK50SE HST, '20 Kioti RX7320
The green/black wire on the back of the wiper switch plug is the one that triggers the wiper motor relay when connected to ground. The brown wire is +12v:
Note that this tractor is a 2013 DK50se HST, your wire colors may be different. But it's easy to find - hook up a 12v test light with the clip end connected to ground, turn the key on, and test each terminal in the plug. When you touch the terminal that makes the wiper move, that's the one.
Note that this tractor is a 2013 DK50se HST, your wire colors may be different. But it's easy to find - hook up a 12v test light with the clip end connected to ground, turn the key on, and test each terminal in the plug. When you touch the terminal that makes the wiper move, that's the one.
SwingOak
Silver Member
- Joined
- Jan 31, 2011
- Messages
- 238
- Tractor
- '65 IH Cub Lo-Boy, '13 Kioti DK50SE HST, '20 Kioti RX7320
I used a 4 pin plug to connect the wiper delay board to make it easier to remove the side panel
SwingOak
Silver Member
- Joined
- Jan 31, 2011
- Messages
- 238
- Tractor
- '65 IH Cub Lo-Boy, '13 Kioti DK50SE HST, '20 Kioti RX7320
I used the relay studs for the ground wire connections for the light bar and side lights, in case you're wondering what those are, but just wanted to share this photo to show which is the wiper relay and which is the aux lighting relay on this tractor:
