8n throttle rod

   / 8n throttle rod #1  

rjhans53

Bronze Member
Joined
May 29, 2014
Messages
51
Location
Mulberry, FL
Tractor
Iseki 1910 Ford 8n B
I really don't think it should be this big of a pain. I changed out the steering box and when I went to put it all back together there is now clear path for the throttle rod. It came out really hard but I just figured it was rust and crud. I've got it back in (and because it was such a pain figured out I'm missing the spring on the bottom) but I've got 3 bends in the rod and it seems to work ok. The ball in the throttle arm is flat and I'll figure that out but is there suppose to be a clear path for the rod or is this typical
 
   / 8n throttle rod #2  
clear path for the rod.

if the ballis flat use a flat blade screwdriver to spread the metal, roll the ball over and then peend the sides a bit.
 
   / 8n throttle rod
  • Thread Starter
#3  
Wow I'm missing something big time. I can't even get a 1/4" rod down straight, It runs into a threaded sleeve. Yep the ball is flat and the bottom spring isn't there. I have a spring ordered
 

Tractor & Equipment Auctions

2019 CATERPILLAR D6T LGP HI TRACK CRAWLER DOZER (A52705)
2019 CATERPILLAR...
2012 CHEVROLET 2500 HD SERVICE TRUCK (A51406)
2012 CHEVROLET...
Light Tower (A52377)
Light Tower (A52377)
2010 UTILITY TRAILER MFG. CO. 53 FOOT FLATBED (A53843)
2010 UTILITY...
2019 INTERNATIONAL LT625 TANDEM AXLE SLEEPER (A53426)
2019 INTERNATIONAL...
BUYERS PREMIUM & PAYMENT TERMS (A54607)
BUYERS PREMIUM &...
 
Top